Hohner Corporation

Home Email Distributors About Us Wireless Advantages How Wireless Works

Receiver Module for Wireless Encoders

Receiver -  A A  -  Z Z Z


Type of output = AA

13 = Standard Quadrature

08 = XML RS232

06 = 4...20 mA (4...20mA span is based on load of 250 ohms)


Options = ZZZZ

X01 = With external antennae

X02 = With external antennae and 4ft (1.2m) cable lead

X03 = With external antennae and 6ft (1.8m) cable lead

X04 = Dual output, 2x A and B channels (can be used together with other options, just append to end of part number)

The Receiver is NOT certified to Intrinsic Safety standards, and therefore should be installed in the safe area.  If it has to go into an Ex Box, we can provide an external antennae.

***click here for old receiver in black housing details***

Technical Data (General)
Operating Temp: -20C to +49C
Housing Material: Plastic
IP rating: IP44
Humidity: 98% permissible
Shock: 10mg (6msec)
Vibration: 5g (500Hz)
Mounting: On to DIN rail
Operating Distance 300 ft max with line of sight
Frequency Band: 124 Channels 2.4 GHz ISM
Security: CRC Check Sum / Unique ID
Data Rate: 250 kbs
Operating Distance 300 ft max with line of sight
Protocol: Proprietary due to low
  power consumption
Data Rate: 250 kbs
Peak RF: 0 dBm, 1mW
General Details:
-Receives data from the sensor
-Electronics built into the module can then convert the data to RS232 for HyperTerminal, Analogue, Voltage and other protocols
-WiFi communication is kept short to avoid battery drainage.
Each encoder has a unique identity number in case multiple sensors are purchased.  The ID numbers can be customer specified.  As default, they be the serial number of the device, this way, there will never be conflicting identities on a system.

Technical Data (For Each Type)
Quadrature Version

Data Transmission:

Data packets are sent out in intervals of 16ms.  Each data packet contains the pulses of what happened in the previous 16ms.  This results in the pulses not coming out evenly spaced.  Quadrature from encoder itself is limited to 2.5kHz.




Connects in same way as normal incremental encoder, channels A and B and power


Power requirements are 12...24V input

RS232 Version
Data Transmission: Data is sent as simple ASCII
Connection 5...24V
4...20 mA Version
Data Transmission 4...20 mA
Connection: 3 wire, 24V
Calibration The 4...20mA span is based on a load of 250 ohms


Hohner Corp. Tel:  1 905 563 4924 and 1 800 295 5693
5536 Regional Road 81 Fax: 1 905 563 7209
Beamsville, Ontario, L0R 1B3 E-mail: hohner@hohner.com
Canada Web: www.encoderonline.com

Hohner Automation Ltd. Tel: +44 (0) 1978 363-888 and 0 845 658 2020
Units 14-16, Whitegate Industrial Estate Fax: +44 (0) 1978 364-586
Wrexham, North Wales, LL13 8UG E-mail: uksales@hohner.com
United Kingdom Web: www.hohneronline.co.uk