Hohner Corporation

Home Email Distributors Terms About Us Accessories Download 3D AutoCAD

Series 08 Incremental DeviceNet Encoder

0   8   X   X - 3   3   X   X - X   X   X   X
  |___|   |  





IP rating

Shaft Size 4 = IP67   0 = DeviceNet Cable
02 = 3/8"     4 = 5 pin micro
10 = 10mm      
12 = 12mm      


Technical Data Encoder Description
Operating temp: - 20 ...+   60 degree C An incremental encoder is coupled to a 32 bit built in counter
- 04 ...+ 140 degree F Value is measured in counts between 0 and 4 294 967 295
On request - 20 .. +100 degree C DeviceNet Service - reset code 05 will reset the counter to 0
Current consumption: 80 mA (max.)
6 ft drop cable Device Configuration
Weight:    32oz (0.90 kg) ODVA profile: Resolver
Protection: IP 67 Explicit Peer to Peer Messaging Not supported
Housing: Stainless Steel I / O Peer to Peer Messaging Not supported
Shaft: Stainless Steel Configuration consistency value Not supported
Bearings: 3 x 6803 ZZ C2 Faulted node recovery Not supported
Torque: 0.4 oz/in (3 N-cm) Baud rate Supported
Humidity: Up to 98% permissible Master / Scanner Not supported
Speed:  3000 RPM max. I / O Slave messaging Not supported
Directions Numbers rising in cw direction Bit strobe Not supported
Poll  Supported
Standards Cyclic Not supported
UL file number  -  198887 Change of state Not supported
European standard EN 50324 EDS
Tested by University of Michigan Vendor ID 34
Devicetype  9
Product code 2
Product name MTDR
Catalog 32 bit incremental encoder
Expected response data 4 bytes
Maximum value 32 bit

Mounting Instructions

Mount fixture to the encoder with three M3 screws.  Slide the encoder onto the shaft.  With the setscrew, tighten the hollow shaft onto the shaft.  Mount the tether on the machine or motor-frame.  The tether can be bent to adapt to any surface.  This assembly allows the encoder to float and increases the lifetime of the bearings.  Connect the encoder as per wiring specifications.  Make sure power supply is within the proper voltage and current rating.  Encoder can be mounted with the setscrew on the machine side or on the opposite side for either CW or CCW.  See datasheet for CW and CCW directions of the outputs.


Technical data for tether:  0.3 mm stainless steel sheet



Hohner Corp. Tel: (905) 563 4924
5536 Regional Road 81 Fax: (905) 563 7209
Beamsville, Ontario E-mail: hohner@hohner.com
Canada L0R 1B3 Web: www.encoderonline.com