hohner

    Hohner Corporation
Home Email Distributors Terms About Us Accessories Download 3D AutoCAD

Series 90 incremental hollow shaft encoder up to 2"
9   0   X   X - 0   1   X   X - X   X   X   X

Shaft Size

  

Connection

   Resolution - ppr

09 = 1 - 1/2"

00 = 9 pole D , output ABO & ABO inv

   - keyway 5/16"

 01 = 9 pole D , output AB & AB inv

11 = 2" 

 02 = 9 pole D , output A & A inv

   - keyway 3/8"

 03 = 6 ft cable , output ABO & ABO inv

15 = 1 - 5/8"

 08 = 12 pole , output ABO & ABO inv
   - keyway 3/8" 10 = 7 pole , output AB & AB inv
16 = 1 - 11/16" 11 = 7 pole , output ABO
18 = 50mm 25 = 12 pole , output AB & AB inv
33 = 1 - 15/16" Other options available
55 = 55 mm  
60 = 60 mm  
78 = 1 - 7/8"  

Select your options below and buy online, easily and securely, with PayPal (from $850)

 Shaft                 Connections                                  Resolution

 

Technical Data Connection Options
Operating temp: - 20 ...+   60 degrees C 7 pin MS 9 pole 12 pole
-   4 ...+ 140 degrees F PS GND F 1 1
Higher Temperature: Please consult PS 5 ... 24 V D 2 2
Max frequency: 100 kHz Output A A 3 3
Current consumption: 80 mA (max.) Output B B 4 4
Power supply: 5 - 24V Output O C 5 7
Weight:    45 oz (1.3 kg) Output A inv G 6 5
Protection: IP 54 NEMA 3 Output B inv E 7 6
Housing: Die Cast Zinc Alloy Output O inv 8 8
Shaft: Aluminum
Bearings: 3 x 6014 ZZ C2 Output
Torque: 20 oz/in (150 N-cm) A is 90 degrees before B in clockwise direction
Humidity: Up to 98% permissible

Speed:  2000 RPM max.
Shock: 10g (6msec)
Vibration: 5g (500 Hz)
Shaft load: Supports its own weight
Line driver  
output max: 50 mA per channel
Max. ppr 5000
            
Mounting Instructions
Mount fixture to the encoder with two self-tapping M6 x 10 screws and two No. 6.2 washers.  Slide the encoder onto the shaft. With two 1/2-13 screws, tighten the encoder fixture to the motor-frame or machine.  With the setscrews, tighten the hollow shaft encoder onto the shaft with a minimum clearance of 1/16" between fixture and encoder by bending the fixture arms as required.  Connect the encoder as per wiring specifications.
Make sure power supply is within the proper voltage and current rating.  Encoder can be mounted with the setscrew on the machine side or on the opposite side for either CW or CCW.  See datasheet for CW and CCW directions of the outputs.

Technical data for tether:  0.3 mm stainless steel sheet
Dimensions

Hohner Corp. Tel: (905) 563 4924
5536 Regional Road 81 Fax: (905) 563 7209
Beamsville, Ontario E-mail: hohner@hohner.com
Canada L0R 1B3 Web: www.encoderonline.com