hohner

    Hohner Corporation
Home Email Distributors Terms About Us Accessories Download 3D AutoCAD

Series 85 incremental hollow shaft encoder up to 5/8"
8   5   X   X - 0   1   X   X - X   X   X   X
  Shaft Size   |____|   Resolution
02 = 3/8"   Connection  
03 = 1/2" 00 = 9 pole D , output ABO & ABO inv
10 =10 mm 01 = 9 pole D , output AB & AB inv
15 = 15 mm 02 = 9 pole D , output A & A inv 
05 = 5/8" with a 03 = 6 ft cable , output ABO & ABO inv
       3/16" keyway 09 = 6 pole , output ABO
12 = 12 mm with a 10 = 7 pole , output AB & AB inv
       4x4 keyway 11 = 7 pole , output ABO
  20 = 6 ft cable , output AB & AB inv
  37 = 6 pole , output AB & AB inv
  Other options available
Technical Data Connection Options
Operating temp: - 20 ...+   60 degrees C 12 pole Cable 7 pole MS
-   4 ...+ 140 degrees F PS GND 1 Black F
Higher Temperature: Please consult PS 5 ... 24 V 2 Blue D
Max frequency: 40 kHz Output A 3 Brown A
Current consumption: 80 mA (max.) Output B 4 Beige B
Power supply: 5 - 24V Output O 5 Pink C
Weight:    7 oz (0.2 kg) Output A inv 6 Yellow G
Protection: IP 54, NEMA 3 Output B inv 7 Green E
Housing: Die Cast Zinc Alloy Output O inv 8 Violet
Shaft: Aluminum
Bearings: 2 x 6902 ZZ C2 Output
Torque: 0.4 oz/in (3 N-cm) A is 90 degrees before B in clockwise direction
Humidity: Up to 98% permissible

Speed:  3000 RPM max.
Shock: 10g (6msec)
Vibration: 5g (500 Hz)
Shaft load: Supports its own weight
Line driver output max: 50 mA per channel
Max. ppr 1024
        
        
Mounting Instructions

Mount fixture to the encoder with three self-tapping no. 8 screws and three no. 8 washers.  Slide the encoder onto the shaft.  With the setscrew, tighten the hollow shaft onto the shaft.  Mount the tether on the machine or motor-frame.  The tether can be bent to adapt to any surface.  This assembly allows the encoder to float and increases the lifetime of the bearings.  Connect the encoder as per wiring specifications.  Make sure power supply is within the proper voltage and current rating.  Encoder can be mounted with the setscrew on the machine side or on the opposite side for either CW or CCW.  See datasheet for CW and CCW directions of the outputs.

 

Technical data for tether:  0.3 mm stainless steel sheet

 
Dimensions

          

Hohner Corp. Tel: (905) 563 4924
5536 Regional Road 81 Fax: (905) 563 7209
Beamsville, Ontario E-mail: hohner@hohner.com
Canada L0R 1B3 Web: www.encoderonline.com